This article will explain the following topics in details: 1) 2) 3) After reading this page, you should be able to understand most of the hardware and software (protocol) standards for RS232. If you have a chance to test your RS232 devices with the 232Analyzer software, you should be able to control your RS232 devices in a short period of time. Step 1: Understand RS232 Connection & Signals RS-232C, EIA RS-232, or simply RS-232, refers to the same standard defined by the Electronic Industries Association in 1969 for serial communication. DTE and DCE DTE stands for Data Terminal Equipment. A computer is a DTE. DCE stands for Data Communication Equipment. A modem is a DCE.
RS232 RS485 RS422 TTL Serial Analyzer Software Designing / debugging a communication project can be very stressful and time-consuming. Many software / site engineers get stuck on the protocol before they can actually control a serial device, such as RS232, RS485, RS422, TTL, Modbus, PLC, or SCADA. B&B Electronics has a free application note available on RS-422/485 that gives a more. In other cases, the 485 device software must use a control line to handle the driver. (If your 485 device is controlled through an RS-232 serial port, this is.
DTE normally comes with a Male Connector, while DCE comes with a Female Connector. However, that is not always true. Use the simple way below to confirm: Measure Pin 3 and Pin 5 of a DB-9 Connector with a Volt Meter, if you get a voltage of -3V to -15V, then it is a DTE device. If the voltage is on Pin 2, then it is a DCE device.
![For For](http://ecx.images-amazon.com/images/I/41%2BUI3o8jeL.jpg)
Note: The result for a DB-25 Connector is reversed (Please refer to DB-9 to DB-25 conversion table below). RS-232 Pin outs (DB-9) A male DB-9 connector viewed from the front. Reverse or back view of male connector for Female Connector.